Jasco Zwave Light Control ZWAVEKIT Manual de usuario

GE SmartHome™Wireless Lighting Control3-wayDimmer Switch Kit45613Z-Wave® Certified Wireless Lighting Control

500WBlue Yellow Yellow White Ground (Green) Green Neutral (White) Auxiliary Switch DimmerSwitch BlackGreen BlackHot (Black)Yellow BlackGreen Hot (Bla

500WBlue Yellow Yellow White Ground (Green) Green Neutral (White) Auxiliary Switch DimmerSwitch BlackGreen BlackHot (Black)Yellow BlackGreen Hot (Bla

White (Neutral)Black (HOT or Load)Traveler (Colored not green)Yellow(Traveler)45607Green (Ground)Blue (Load)Black (HOT or Load)

Red/White(Hot)Traveler(color not green)Green (grounded)45610Yellow(traveler)Black(Hot)

SHOCK HAZARD! Turn OFF the power to the branch circuit at the circuit breaker in your electrical service panel. Ensure power is OFF before you instal

Instructions:Strip insulation 3/8” for 12 or 14 AWG wire. Strip insulation 7/16” for 16 or 18 AWG wire.Hold stripped ends together in parallel and al

Key Features- Controls one light from two locations- Remote On/Off/Brightness control via the Z-Wave controller/network- Manual On/Off/Brightness cont

must still tap (press & release) the bottom of the rocker to turn the power OFF. - When OFF, pressing and holding the bottom of the rocker will

ADVANCED OPERATIONThe following Advanced Operation parameters require that you have an advanced controller like the 45601 Advanced remote. Advanced r

- Parameter No: 3- Length: 1 Byte- Valid Values = 0 or 1 (default 0)Invert SwitchIf the dimmer switch is accidentally installed upside down with “On”

Introduction:Thank you for your purchase of a GE Z-Wave® enabled control device. Z-Wave technology is designed to automate lighting/home control and

- Valid Values:Parameter 7 (default = 1) Valid Values: 1-99Parameter 8 (default = 3) Valid Values: 1-2552. Manual Control Dimming (pressing the Dimmer

Restoring Factory DefaultsAll Configuration Parameters can all be restored to their factory default settings by using your master controller to reset t

FCC U2Z45606-7The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:The equipment has been test

This Class B digital device complies with Canadian ICES-003.SPECIFICATIONSPower: 120 VAC, 60 Hz.Signal (Frequency): 908.42 MHz.Minimum Load: 40W, inca

is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma

The auxiliary switch is not Z-Wave enabled and does not directly control electrical loads. It must be used with a compatible Z-Wave enabled, 3-wire s

RISK OF FIRERISK OF ELECTRICAL SHOCKRISK OF BURNSWARNINGControlling Appliances:Exercise extreme caution when using Z-Wave devices to control appliance

Wireless RangeThis device complies with the Z-Wave standard of open-air, line of sight transmission distances of 65 feet. Actual performance in a hom

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth® and other 2.4GHz or 5

Typical 3-way circuitCorrect switch position Incorrect switch position Refer to the wiring diagram for wiring detailsZ-Wave Auxiliary Z-Wave Primary Z

IMPORTANT NOTE ABOUT 3-WAY CIRCUITS CONT.The yellow wire from the 45607 must only be connected to the yellow wire of the 45610 via the traveler wire.